Compression Hinge-Latch without Safety Catch - 3D Adjustable

Compression Hinge-Latch without Safety Catch - 3D Adjustable

Compression Hinge-Latch without Safety Catch - 3D Adjustable

Latching Hinge that may be used as hinge or latch according to need. Allows you to open door as left- or right hinged door, or to remove door completely. Universal left- and right assembly. Available with a built-in safety catch for safe opening of pressurized doors. In addition to the 3 mm compression that always applies, the Hinge Latch can easily be adjusted between offset 0 mm, 1,5 mm or 3,0 mm to put more pressure on the gasket and ensure a tight and sealed door. This adjusting is done by lifting the cover and turning the adjustment screw using a "Torx 20"-bit. Door part mounts on a mounting bracket (included) which stabilize the door in the Latching Hinge area and provide further adjustability. The Latching Hinge can be adjusted 3 mm in all three directions. Clicks into distinct open and closed position for tactile feedback and equipped with insert "Recessed hexagon 8 mm". Supplied with open and close indication for insert position.

Also customizable with your logotype (logotype area prepared). Frame part mounts with screws or blind rivets. Mounting bracket for the door mounts with Ø 4 mm blind rivets (pop-rivets). Mounting hardware not included.

Note that a normal panel will need four units in order to operate as either left-open, right open, or completely removable.

When mounted in a properly rated, suitable enclosure this handle meets the requirements for sealing level L1 regarding positive or negative air pressure according to DIN EN 1886.

No problems with thermal break as units are surface-mounted on to door and frame parts, resulting in no parts intruding through the double skinned doors.